tilcdc_drv.h

  1/* SPDX-License-Identifier: GPL-2.0-only */
  2/*
  3 * Copyright (C) 2012 Texas Instruments
  4 * Author: Rob Clark <robdclark@gmail.com>
  5 */
  6
  7#ifndef __TILCDC_DRV_H__
  8#define __TILCDC_DRV_H__
  9
 10#include <linux/cpufreq.h>
 11#include <linux/irqreturn.h>
 12
 13#include <drm/drm_print.h>
 14
 15struct clk;
 16struct workqueue_struct;
 17
 18struct drm_connector;
 19struct drm_connector_helper_funcs;
 20struct drm_crtc;
 21struct drm_device;
 22struct drm_display_mode;
 23struct drm_encoder;
 24struct drm_framebuffer;
 25struct drm_minor;
 26struct drm_pending_vblank_event;
 27struct drm_plane;
 28
 29/* Defaulting to pixel clock defined on AM335x */
 30#define TILCDC_DEFAULT_MAX_PIXELCLOCK  126000
 31/* Maximum display width for LCDC V1 */
 32#define TILCDC_DEFAULT_MAX_WIDTH_V1  1024
 33/* ... and for LCDC V2 found on AM335x: */
 34#define TILCDC_DEFAULT_MAX_WIDTH_V2  2048
 35/*
 36 * This may need some tweaking, but want to allow at least 1280x1024@60
 37 * with optimized DDR & EMIF settings tweaked 1920x1080@24 appears to
 38 * be supportable
 39 */
 40#define TILCDC_DEFAULT_MAX_BANDWIDTH  (1280*1024*60)
 41
 42
 43struct tilcdc_drm_private {
 44	void __iomem *mmio;
 45
 46	struct clk *clk;         /* functional clock */
 47	int rev;                 /* IP revision */
 48
 49	unsigned int irq;
 50
 51	/* don't attempt resolutions w/ higher W * H * Hz: */
 52	uint32_t max_bandwidth;
 53	/*
 54	 * Pixel Clock will be restricted to some value as
 55	 * defined in the device datasheet measured in KHz
 56	 */
 57	uint32_t max_pixelclock;
 58	/*
 59	 * Max allowable width is limited on a per device basis
 60	 * measured in pixels
 61	 */
 62	uint32_t max_width;
 63
 64	/* Supported pixel formats */
 65	const uint32_t *pixelformats;
 66	uint32_t num_pixelformats;
 67
 68#ifdef CONFIG_CPU_FREQ
 69	struct notifier_block freq_transition;
 70#endif
 71
 72	struct workqueue_struct *wq;
 73
 74	struct drm_crtc *crtc;
 75
 76	unsigned int num_encoders;
 77	struct drm_encoder *encoders[8];
 78
 79	unsigned int num_connectors;
 80	struct drm_connector *connectors[8];
 81
 82	struct drm_encoder *external_encoder;
 83	struct drm_connector *external_connector;
 84
 85	bool is_componentized;
 86	bool irq_enabled;
 87};
 88
 89/* Sub-module for display.  Since we don't know at compile time what panels
 90 * or display adapter(s) might be present (for ex, off chip dvi/tfp410,
 91 * hdmi encoder, various lcd panels), the connector/encoder(s) are split into
 92 * separate drivers.  If they are probed and found to be present, they
 93 * register themselves with tilcdc_register_module().
 94 */
 95struct tilcdc_module;
 96
 97struct tilcdc_module_ops {
 98	/* create appropriate encoders/connectors: */
 99	int (*modeset_init)(struct tilcdc_module *mod, struct drm_device *dev);
100#ifdef CONFIG_DEBUG_FS
101	/* create debugfs nodes (can be NULL): */
102	int (*debugfs_init)(struct tilcdc_module *mod, struct drm_minor *minor);
103#endif
104};
105
106struct tilcdc_module {
107	const char *name;
108	struct list_head list;
109	const struct tilcdc_module_ops *funcs;
110};
111
112void tilcdc_module_init(struct tilcdc_module *mod, const char *name,
113		const struct tilcdc_module_ops *funcs);
114void tilcdc_module_cleanup(struct tilcdc_module *mod);
115
116/* Panel config that needs to be set in the crtc, but is not coming from
117 * the mode timings.  The display module is expected to call
118 * tilcdc_crtc_set_panel_info() to set this during modeset.
119 */
120struct tilcdc_panel_info {
121
122	/* AC Bias Pin Frequency */
123	uint32_t ac_bias;
124
125	/* AC Bias Pin Transitions per Interrupt */
126	uint32_t ac_bias_intrpt;
127
128	/* DMA burst size */
129	uint32_t dma_burst_sz;
130
131	/* Bits per pixel */
132	uint32_t bpp;
133
134	/* FIFO DMA Request Delay */
135	uint32_t fdd;
136
137	/* TFT Alternative Signal Mapping (Only for active) */
138	bool tft_alt_mode;
139
140	/* Invert pixel clock */
141	bool invert_pxl_clk;
142
143	/* Horizontal and Vertical Sync Edge: 0=rising 1=falling */
144	uint32_t sync_edge;
145
146	/* Horizontal and Vertical Sync: Control: 0=ignore */
147	uint32_t sync_ctrl;
148
149	/* Raster Data Order Select: 1=Most-to-least 0=Least-to-most */
150	uint32_t raster_order;
151
152	/* DMA FIFO threshold */
153	uint32_t fifo_th;
154};
155
156#define DBG(fmt, ...) DRM_DEBUG(fmt"\n", ##__VA_ARGS__)
157
158int tilcdc_crtc_create(struct drm_device *dev);
159irqreturn_t tilcdc_crtc_irq(struct drm_crtc *crtc);
160void tilcdc_crtc_update_clk(struct drm_crtc *crtc);
161void tilcdc_crtc_set_panel_info(struct drm_crtc *crtc,
162		const struct tilcdc_panel_info *info);
163void tilcdc_crtc_set_simulate_vesa_sync(struct drm_crtc *crtc,
164					bool simulate_vesa_sync);
165void tilcdc_crtc_shutdown(struct drm_crtc *crtc);
166void tilcdc_crtc_destroy(struct drm_crtc *crtc);
167int tilcdc_crtc_update_fb(struct drm_crtc *crtc,
168		struct drm_framebuffer *fb,
169		struct drm_pending_vblank_event *event);
170
171int tilcdc_plane_init(struct drm_device *dev, struct drm_plane *plane);
172
173#endif /* __TILCDC_DRV_H__ */