panel-ronbo-rb070d30.c

  1// SPDX-License-Identifier: GPL-2.0+
  2/*
  3 * Copyright (C) 2018-2019, Bridge Systems BV
  4 * Copyright (C) 2018-2019, Bootlin
  5 * Copyright (C) 2017, Free Electrons
  6 *
  7 * This file based on panel-ilitek-ili9881c.c
  8 */
  9
 10#include <linux/delay.h>
 11#include <linux/device.h>
 12#include <linux/err.h>
 13#include <linux/errno.h>
 14#include <linux/kernel.h>
 15#include <linux/media-bus-format.h>
 16#include <linux/module.h>
 17#include <linux/of.h>
 18
 19#include <linux/gpio/consumer.h>
 20#include <linux/regulator/consumer.h>
 21
 22#include <drm/drm_connector.h>
 23#include <drm/drm_mipi_dsi.h>
 24#include <drm/drm_modes.h>
 25#include <drm/drm_panel.h>
 26
 27struct rb070d30_panel {
 28	struct drm_panel panel;
 29	struct mipi_dsi_device *dsi;
 30	struct regulator *supply;
 31
 32	struct {
 33		struct gpio_desc *power;
 34		struct gpio_desc *reset;
 35		struct gpio_desc *updn;
 36		struct gpio_desc *shlr;
 37	} gpios;
 38};
 39
 40static inline struct rb070d30_panel *panel_to_rb070d30_panel(struct drm_panel *panel)
 41{
 42	return container_of(panel, struct rb070d30_panel, panel);
 43}
 44
 45static int rb070d30_panel_prepare(struct drm_panel *panel)
 46{
 47	struct rb070d30_panel *ctx = panel_to_rb070d30_panel(panel);
 48	int ret;
 49
 50	ret = regulator_enable(ctx->supply);
 51	if (ret < 0) {
 52		dev_err(&ctx->dsi->dev, "Failed to enable supply: %d\n", ret);
 53		return ret;
 54	}
 55
 56	msleep(20);
 57	gpiod_set_value_cansleep(ctx->gpios.power, 1);
 58	msleep(20);
 59	gpiod_set_value_cansleep(ctx->gpios.reset, 1);
 60	msleep(20);
 61	return 0;
 62}
 63
 64static int rb070d30_panel_unprepare(struct drm_panel *panel)
 65{
 66	struct rb070d30_panel *ctx = panel_to_rb070d30_panel(panel);
 67
 68	gpiod_set_value_cansleep(ctx->gpios.reset, 0);
 69	gpiod_set_value_cansleep(ctx->gpios.power, 0);
 70	regulator_disable(ctx->supply);
 71
 72	return 0;
 73}
 74
 75static int rb070d30_panel_enable(struct drm_panel *panel)
 76{
 77	struct rb070d30_panel *ctx = panel_to_rb070d30_panel(panel);
 78
 79	return mipi_dsi_dcs_exit_sleep_mode(ctx->dsi);
 80}
 81
 82static int rb070d30_panel_disable(struct drm_panel *panel)
 83{
 84	struct rb070d30_panel *ctx = panel_to_rb070d30_panel(panel);
 85
 86	return mipi_dsi_dcs_enter_sleep_mode(ctx->dsi);
 87}
 88
 89/* Default timings */
 90static const struct drm_display_mode default_mode = {
 91	.clock		= 51206,
 92	.hdisplay	= 1024,
 93	.hsync_start	= 1024 + 160,
 94	.hsync_end	= 1024 + 160 + 80,
 95	.htotal		= 1024 + 160 + 80 + 80,
 96	.vdisplay	= 600,
 97	.vsync_start	= 600 + 12,
 98	.vsync_end	= 600 + 12 + 10,
 99	.vtotal		= 600 + 12 + 10 + 13,
100
101	.width_mm	= 154,
102	.height_mm	= 85,
103};
104
105static int rb070d30_panel_get_modes(struct drm_panel *panel,
106				    struct drm_connector *connector)
107{
108	struct rb070d30_panel *ctx = panel_to_rb070d30_panel(panel);
109	struct drm_display_mode *mode;
110	static const u32 bus_format = MEDIA_BUS_FMT_RGB888_1X24;
111
112	mode = drm_mode_duplicate(connector->dev, &default_mode);
113	if (!mode) {
114		dev_err(&ctx->dsi->dev, "Failed to add mode " DRM_MODE_FMT "\n",
115			DRM_MODE_ARG(&default_mode));
116		return -EINVAL;
117	}
118
119	drm_mode_set_name(mode);
120
121	mode->type = DRM_MODE_TYPE_DRIVER | DRM_MODE_TYPE_PREFERRED;
122	drm_mode_probed_add(connector, mode);
123
124	connector->display_info.bpc = 8;
125	connector->display_info.width_mm = mode->width_mm;
126	connector->display_info.height_mm = mode->height_mm;
127	drm_display_info_set_bus_formats(&connector->display_info,
128					 &bus_format, 1);
129
130	return 1;
131}
132
133static const struct drm_panel_funcs rb070d30_panel_funcs = {
134	.get_modes	= rb070d30_panel_get_modes,
135	.prepare	= rb070d30_panel_prepare,
136	.enable		= rb070d30_panel_enable,
137	.disable	= rb070d30_panel_disable,
138	.unprepare	= rb070d30_panel_unprepare,
139};
140
141static int rb070d30_panel_dsi_probe(struct mipi_dsi_device *dsi)
142{
143	struct rb070d30_panel *ctx;
144	int ret;
145
146	ctx = devm_drm_panel_alloc(&dsi->dev, struct rb070d30_panel, panel,
147				   &rb070d30_panel_funcs,
148				   DRM_MODE_CONNECTOR_DSI);
149	if (IS_ERR(ctx))
150		return PTR_ERR(ctx);
151
152	ctx->supply = devm_regulator_get(&dsi->dev, "vcc-lcd");
153	if (IS_ERR(ctx->supply))
154		return PTR_ERR(ctx->supply);
155
156	mipi_dsi_set_drvdata(dsi, ctx);
157	ctx->dsi = dsi;
158
159	ctx->gpios.reset = devm_gpiod_get(&dsi->dev, "reset", GPIOD_OUT_LOW);
160	if (IS_ERR(ctx->gpios.reset)) {
161		dev_err(&dsi->dev, "Couldn't get our reset GPIO\n");
162		return PTR_ERR(ctx->gpios.reset);
163	}
164
165	ctx->gpios.power = devm_gpiod_get(&dsi->dev, "power", GPIOD_OUT_LOW);
166	if (IS_ERR(ctx->gpios.power)) {
167		dev_err(&dsi->dev, "Couldn't get our power GPIO\n");
168		return PTR_ERR(ctx->gpios.power);
169	}
170
171	/*
172	 * We don't change the state of that GPIO later on but we need
173	 * to force it into a low state.
174	 */
175	ctx->gpios.updn = devm_gpiod_get(&dsi->dev, "updn", GPIOD_OUT_LOW);
176	if (IS_ERR(ctx->gpios.updn)) {
177		dev_err(&dsi->dev, "Couldn't get our updn GPIO\n");
178		return PTR_ERR(ctx->gpios.updn);
179	}
180
181	/*
182	 * We don't change the state of that GPIO later on but we need
183	 * to force it into a low state.
184	 */
185	ctx->gpios.shlr = devm_gpiod_get(&dsi->dev, "shlr", GPIOD_OUT_LOW);
186	if (IS_ERR(ctx->gpios.shlr)) {
187		dev_err(&dsi->dev, "Couldn't get our shlr GPIO\n");
188		return PTR_ERR(ctx->gpios.shlr);
189	}
190
191	ret = drm_panel_of_backlight(&ctx->panel);
192	if (ret)
193		return ret;
194
195	drm_panel_add(&ctx->panel);
196
197	dsi->mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST | MIPI_DSI_MODE_LPM;
198	dsi->format = MIPI_DSI_FMT_RGB888;
199	dsi->lanes = 4;
200
201	ret = mipi_dsi_attach(dsi);
202	if (ret < 0) {
203		drm_panel_remove(&ctx->panel);
204		return ret;
205	}
206
207	return 0;
208}
209
210static void rb070d30_panel_dsi_remove(struct mipi_dsi_device *dsi)
211{
212	struct rb070d30_panel *ctx = mipi_dsi_get_drvdata(dsi);
213
214	mipi_dsi_detach(dsi);
215	drm_panel_remove(&ctx->panel);
216}
217
218static const struct of_device_id rb070d30_panel_of_match[] = {
219	{ .compatible = "ronbo,rb070d30" },
220	{ /* sentinel */ },
221};
222MODULE_DEVICE_TABLE(of, rb070d30_panel_of_match);
223
224static struct mipi_dsi_driver rb070d30_panel_driver = {
225	.probe = rb070d30_panel_dsi_probe,
226	.remove = rb070d30_panel_dsi_remove,
227	.driver = {
228		.name = "panel-ronbo-rb070d30",
229		.of_match_table	= rb070d30_panel_of_match,
230	},
231};
232module_mipi_dsi_driver(rb070d30_panel_driver);
233
234MODULE_AUTHOR("Boris Brezillon <boris.brezillon@bootlin.com>");
235MODULE_AUTHOR("Konstantin Sudakov <k.sudakov@integrasources.com>");
236MODULE_DESCRIPTION("Ronbo RB070D30 Panel Driver");
237MODULE_LICENSE("GPL");